Assemble Instruction for our Cargo Bike for children

Read and understand these instructions before you begin the assembly. The bike comes partly assembled, and it is important to read the manual carefully before starting assembly, so the bicycle will be assembled in the correct order.

Be aware that the bike must be re-tightened after approx. 20 km. Make sure to check all parts of the bike and re-tighten all moving parts, including brake, spokes, bolts and nuts.

Step 1: Assembly of the back and front frame

Parts you need in step 1

4 pc. corner brackets
16 pc. short bolts
16 stk. washers
16 stk. round nuts

4 pc. angle brackets
4 pc. short bolts
4 pc. washers
4 pc. lock nuts

When the parts have been taken out of the boxes and wrapping, the four corner brackets are mounted as shown in picture 1A and 1B. Notice that the brackets with the bushings for the handlebar must face the back end of the bike.
The front reflector is mounted – see picture 1C.
The two bolts for mounting of the handle bar is placed in the corner brackets – see picture 1D and 1E.
The angle brackets are mounted on the side plates as shown in picture 1F and 1G.

Picture 1A

Picture 1B

Picture 1C

Picture 1D

Picture 1E

Picture 1F

Picture 1G

Step 2: Fenders, front wheels and brake pads

Parts you need in step 2

2 pc. front fenders
8 pc. small bolts
8 pc. small washers

The front fenders are mounted – ses picture 2A and 2B
The front wheels are mounted – see picture 2C

Picture 2A

Picture 2B

Picture 2C

Step 3: Assemble the box

Parts you need in step 3

4 pc. long bolts
4 pc. washers
4 pc. lock nuts

The box and the bottom plate are mounted on the frame – see picture 3A and 3B. The four long bolts should sit through the angle brackets, through the bottom plate and through the holes in the frame.
The handle bar is mounted – see picture 3C

Picture 3A

Picture 3B

Picture 3C

Step 4: The rest of the equipment

Parts you need in step 4

The cargo box frame and back frame are assembled using the bearings and bit nuts – see picture 4A and 4B
The pedals and the sadle is mounted – see picture 4C, 4D and 4E

Picture 4A